稀土复合型柴油催化助燃剂的研制及应用

采用铈、铂的有机配合物及碳酸酯制备出一种稀土复合型柴油催化助燃剂.通过发动机台架试验,表明添加剂可有效降低碳烟PM和NOz排放,并且发动机热效率有所提高.     

A microfluidic device using a green organic light emitting diode as an integrated excitation source

A simply fabricated microfluidic device using a green organic light emitting diode (OLED) and thin film interference filter as integrated excitation source is presented and applied to fluorescence detection of proteins. A layer-by-layer compact system consisting of glass/PDMS microchip, pinhole, excitation filter and OLED is designed and equipped with a coaxial optical fiber and for fluorescence detection a 300 microm thick excitation filter is employed for eliminating nearly 80% of the unwanted light emitted by OLEDs which has overlaped with the fluorescence spectrum of the dyes. The distance between OLED illuminant and microchannels is limited to approximately 1 mm for sensitive detection. The achieved fluorescence signal of 300 microM Rhodamine 6G is about 13 times as high as that without the excitation filter and 3.5 times the result of a perpendicular detection structure. This system has been used for fluorescence detection of Rhodamine 6G, Alexa 532 and BSA conjugates in 4% linear polyacrymide (LPA) buffer (in 1 x TBE, pH 8.3) and 1.4 fmol and 35 fmol mass detection limits at 0.7 nl injection volume for Alexa and Rhodamine dye have been obtained, respectively.     

Statistics aided optimization for high-performance liquid chromatographic analysis of organic acids in tobacco

HPLC analysis for organic acids in tobacco was optimized with the aid of statistical experimental design, a central composite face-centered design. In the design, only thirteen HPLC analyses were needed for identifying two optimal separation parameters. A Bio-Rad Aminex HPX-87H column was used for the analyses. An optimal separation for seven acids in tobacco was found at a temperature of 57 degrees C and a mobile phase of 0.032 N sulfuric acid solution, or at a temperature of 70 degrees C and a mobile phase of 0.024 N sulfuric acid solution, with a flow rate of 0.6 ml min(-1).     

新型含金属元素二胺的合成与表征

本文分别用液相法和固相法合成了一系列含不同金属元素的二胺,并通过红外光谱,~1HNMR、~(13)CNMR,紫外光谱,电化学分析及元素分析对其进行表征,还通过DSC和TG对其热性能进行了研究,结果发现这些二胺具有良好的耐热性,是合成一些耐热高聚物的优良原料.     

Cyanex272-P507浸渍树脂协同萃取色层分离铥镱镥的研究

以Cyanex272-P507浸渍树脂采用萃取色层法对铥镱镥富集物进行了吸附和淋洗分离研究,考察了淋洗剂浓度、稀土负载量、淋洗液流速等因素对分离铥镱镥富集物的影响。结果表明,在充填的树脂粒度为0.3~0.6 mm的色层柱中,以0.2 ml.cm-2.min-1进料流速时能得到较大的吸附率;在稀土负载量为树脂重量的0.6%,淋洗液流速为1.0 ml.cm-2.min-1,温度为30℃,装柱树脂高度为400 mm(高径比为25∶1)的条件下,用1.0,1.5,2.0 mol.L-1盐酸梯度淋洗Tm,Yb,Lu,可实现铥镱镥富集物三者的完全分离。     

甲醇与乙醇一步合成异丁醛用CuO-ZnO/Al2O3催化剂

在ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３催化剂上，甲醇与乙醇在常压和２１０￣３６０℃温度下一步反应合成异丁醛。利用正交设计方法，研究了ＣｕＯ－ＺｎＯ／Ａｌ２Ｏ３体系催化剂组成和制备条件等因素对催化剂催化性能的影响。结果表明，催化剂中ＣｕＯ含量对催化剂的催化活性影响最大，而ＺｎＯ含量则主要影响催化剂对异丁醛的选择性。催化剂制备条件，如沉淀温度、陈化时间等，也不同程度也影响催化剂的催化性能。ＸＲＤ和ＢＥＴ表征结果     

四种溴代甲苯异构体的质谱区分

本工作用四种较新的质谱技术(碰撞诱导解离(CID),电荷剥离(CS),电荷分离(CSe),电子捕获诱导解离(ECID)谱研究了邻、间、对溴甲苯和溴化苄四种异构体。四种技术在一定程度上都可区分这些异构体。其中比较四种异构体ECID谱中ECID峰的相对强度可得到满意的区分效果。     

ADSORPTION OF 2,4-DICHLOROBENZOXYACETIC ACID ONTO HYPERCROSSLINKED RESIN MODIFIED BY PHENOLIC HYDROXYL GROUP (AM-1)

INTRODUCTIONAdsorption has been considered to be the best available technology for removing organics from water in the USSafe Drinking Water Act[1]. Due to many drawbacks of activated carbon[2-7], the most widely used adsorbent,hypercrosslinked polymeric adsorbents developed by Tsyurupa and Davankov[8] have been increasingly viewedas an alternative to activated carbon for selective removal of specific organic substances from contaminatedwater[9-12], and series of researches have been do…     

Biocomposites of covalently linked glucose oxidase on carbon nanotubes for glucose biosensor

The formation of covalently linked composites of multi–walled carbon nanotubes (MWCNT) and glucose oxidase (GOD) with high-function density for use as a biosensing interface is described. The reaction intermediates and the final product were characterized by using FT–IR spectroscopy, and the MWCNT-coated GOD nanocomposites were examined by atomic force microscopy (AFM) and transmission electron microscopy (TEM). Interestingly, it was found that the GOD–MWCNT composites are highly water soluble. Electrochemical characterization of the GOD–MWCNT composites that were modified on a glassy carbon electrode shows that the covalently linked GOD retains its bioactivity and can specifically catalyze the oxidation of glucose. The oxidation current shows a linear dependence on the glucose concentration in the solution in the range of 0.5–40 mM with a detection limit of 30 μM and a detection sensitivity of 11.3 μA/mMcm². The present method may provide a way to synthesize MWCNT related composites with other biomolecules and for the construction of enzymatic reaction-based biofuel cells and biosensors. Supported by grants from the National Natural Science Foundation of China (NSFC, No. 20125515; 90206037; 20375016) and the Natural Science Foundation of Jiangsu Province (Grant No. BK 2004210)     

钛酸盐功能材料的研究与应用

本文综述了钛酸盐功能材料的各种性质、合成方法及用途。指出关于新型钛酸盐产品的制备、新性能的发现及寻求新的应用领域是一项值得深入研究的课题。